FRP and mold release wax releasing agent

FRP and Mold Release wax  releasing agent 

PASTEWAX is formulated with synthetic waxes and high heat resistant resins for easy release of most FRP &plastic parts thru multiple cycles

Directions:

Mold preparation involves 3 process: cleaning, sealing &release.

This procedure applies to new, used and reconditioned molds prior to placing them in production.

Cleaning:

Step 1: Wash entire mold with soap and water , use FK’s #118SC, Shampoo Concentrate. Rinse and wipe dry.

Step 2: Apply EITHER FK’s #135-80, mold cleaner&wax remover or #69 liquid cleaner&stripper with terry cloth applicator by wetting the surface thoroughly. Agitate and wipe while wet to remove the residues. Do not use rice paper. Please note #135-80 is a better cleaner than 69#.

Step 3: Reapply #135-80 or 69#, allow it to dry thoroughly and wipe off the film. At this point surface should be friction free, bright and shiny.

SEALING:

Step 4: Apply one coat of FK’s #86, seal kote, allow it to dry thoroughly for 30 minutes and wipe gently.

Step 5: Apply 3 more coats of 86# in similar manner and allow it to dry then wipe gently. Let is set for a minimum of 1 hour to allow polymer to set and bond to the mold. Wipe lightly with soft clean cloth for a nice shine.

RELEASE:

Step 6: Apply an even coat of paste wax with applicator supplied, allow it to dry thoroughly&wipe gently with clean cloth. Use a minimum of five coats total. Allowing each coat to dry prior tp wiping it gently so as not to remove the wax. After first parts is released, re-wax once more with the paste wax, allow it to dry and wipe gently. At this point , multiple releases are possible without re-waxing.

Some people use FK’s #1000L in between each release as added insurance-we agree with this practice.

Note: To prevent excessive wax build up and as a routine preventive mold maintenance program, periodically use a coat of FK’s #1000L in between each release as added insurance-we agree with this practice, use a coat of FK’s #1000L, liquid mold release to envenly distribute the wax and smooth out the mold release surface. If hazing or dullness appears, clean the mold with FK’s #69.

FK’s paste wax, #1000L liquid wax and either #135-80 or 69#.